Rövid információ: 1.Independent Dual-spring Design
A complete redesign of the traditional OE two-stage
structure,
replacing it with a more robust and fatigue-resistant
independent system.

2.High-performance Transmission Gears
Main Gear: PPA + GF30 + 15% PTFE Sector Gear: PA66 + GF43

3.Integrated Hall Sensor Technology
A fully integrated Hall chip replaces the OE layout of wires
and solder joints, removing common failure points.

Általános információ: Az általunk szállított termékek kizárólag
rendeltetésszerű használatra felelnek meg. A
beszerelést csak szakképzett személyzet végfezheti. A
termékek általában szerelési utasítás nélkül
kerülnek kiszállításra.

Általános információ: Any and all spare parts we supply are solely intended for
the designated purpose as defined by us.
Installation by trained personnel only.
Our products are usually supplied without assembly
instructions.
Installation in vehicles other than those specified by
us may lead to the exclusion of warranty.

Általános információ: Any and all spare parts we supply are solely intended for
the designated purpose as defined by us.
Installation by trained personnel only.
Our products are usually supplied without assembly
instructions.
Installation in vehicles other than those specified by
us may lead to the exclusion of warranty.
Műszaki információ: do not touch plug contacts !

Általános információ: Products supplied by us are without exception intended for
the designated use.
Please note that our products are usually delivered without
installation instructions.
Installation may only be carried out by trained specialist
personnel.
There is no guarantee for inappropriate, improper or
unintended use.

Általános információ: In the warranty, we always make a distinction between wear
parts and vehicle parts. All wear parts are subject to a
reduced warranty period and a maximum mileage.

Brake components such as brake disks, brake pads, etc.
maximum of 1000 km (break-in period). Therefore, warranty
claims for brake parts are only reviewed with an
installation invoice and a record of the wheel hub run-out
measurement, including photos.

For brake disks and brake pads, the break-in requirements
specified by the vehicle manufacturer must be observed.

When replacing brakes, the chassis components must always be
checked with regard to clearance and the wheel hub with
regard to wobble, and the appropriate documentation must be
produced.

If the vehicle is no longer in its original condition due to
tuning work such as wheel accessories and tracking plates,
the entitlement to make warranty claims is lost due to
third-party work. The same warranty claims are lost if the
vehicle is used for motor sports or similar events.

Általános információ: Hoffer: 7519060

Általános információ: Nissens: 955088

Általános információ: NRF: 408068

Általános információ: Products and spare parts supplied by us are only intended
for the designated use. Installation may only be carried out
by trained specialist personnel. Our products are not always
supplied with installation instructions. Improper
installation or inappropriate use may lead to the exclusion
of warranty.

Általános információ: Products and spare parts supplied by us are only intended
for the designated use. Installation may only be carried out
by trained specialist personnel. Our products are not always
supplied with installation instructions. Improper
installation or inappropriate use may lead to the exclusion
of warranty.